Table of Contents
Advertisement
Appendix 1 – Hardware Installation
Attaching Antennas
Screw the antennas clockwise onto the antenna
connectors on the sides of your NWA1100-N. The
antennas should be perpendicular to the ground
and parallel to each other. Make sure the antennas
are securely screwed onto the antenna connectors.
Hardware Mounting
In general, the best location for the access point is at the center of your
intended wireless coverage area. For better performance, mount the
NWA1100-N high up in an area that is free of obstructions.
Wall-mounting
Step 1: Screw the two screws provided with your NWA1100-N into the wall
60mm apart (see the figure in step 3). Use screws with 6mm ~ 8mm (0.24" ~
0.31") wide heads. Do not screw the screws all the way in to the wall; leave a
small gap between the head of the screw and the wall. The gap must be big
enough for the screw heads to slide into the screw slots and the connection
cables to run down the back of the NWA1100-N. Make sure the screws are
securely fixed to the wall and strong enough to hold the weight of the Access
Point with the connection cables.
Step 2: Adjust the cables. Run the connection cables down the back of the
NWA1100-N as shown in the following figure. Alternatively, run the
connection cables upward and along the edge of the ceiling.
Step 3: Align the holes on the back of the NWA1100-N with the screws on
the wall. Hang the NWA1100-N on the screws
Page 12
Advertisement
Table of Contents
