Advertisement
MAINTENANCE OPERATIONS
3—17
Sorew in new bulb; bayonet socket: Turn new bulb to
the right and pull back to the stop.
3.3.10 Checking the chain tension
(to be carried out with the vehicle under load)
The chain must be neither too loose nor too strongly
tensioned. In the middle between the two chain sprockets,
it must easily go up and down by 10 to 15 mm. When
checking the chain tension (first loosen wheel nuts), take
care to tight equally the two chain tightener for the
wheel to keep in track. Do not forget tightening the
counter-nuts.
3.3.11 Setting the gear shifting mechanism
Setting the gear change or adjusting it anew is only
required with handoperated gear change models.
0
Jack up the vehicle.
#
Place control lever upon gearbox in — for bowden
<y
nspi
r-M
IOB
0
cm
1 m m
Fig. 15
Fig. 16
Advertisement
