Steering Lock Removal With Lock In Lock Position; Adjusting The Headlight - PIAGGIO X9 500 cc Service Manual

- Push the bolt lightly and extract the retainer from the
milled part shown in the figure.
- Extract the bolt assembly from the lock body.
- To refit, follow the reverse procedure.
Removal with lock in LOCK position
The bolt retaining spring is not accessible in the LOCK
position. It is then necessary to drill the bolt as show in
the figure to eject it.
Note: To refit the bolt from this position, first disengage
the steering lock by putting the lock body (inner and
outer part) in the OFF position.
Proceed as described in the previous paragraph.

Adjusting the headlight

- Place the unloaded vehicle on a level surface, 10
metres from a half-lit white screen, with the tyres
inflated to the prescribed pressure. Ensure that the
axis of the vehicle is perpendicular to the screen.
- Draw a horizontal line on the screen 70-73 cm above
the ground.
- Switch on the headlight, turn on the low beam and
check that the horizontal line that divides the dark
area from the lighted area is not above the line
previously drawn on the screen. To shift the head-
light, use the specially designed screw in the front
shield (see figure).
Maintenance
03_016
3
03_017
03_018
3 - 9