Power Reset - ABTronic 2X Instructions Manual

LCD Display
lights up, but
all buttons do
not work
Tip: You can determine whether your conductive pads are worn out
and need replacing or whether the electronic unit does not generate
sufficient output power. Simply unsnap the unit from the belt. Place a
little bit of conductive gel on the tip of the pointing and ring finger of
one hand and press your fingers against the contacts of the unit.
Switch the unit on and carefully increase intensity to level one or two.
If the unit is working properly you will feel a tingling sensation in your
fingers which indicates that you need to get new conductive pads.
IMPORTANT: POWER RESET
If the unit does not switch on, or if you can't change to different
programs, the microprocessor may have "hanged". Please perform a
simple RESET. Remove batteries and replace them after one minute.
Design and Engineering in Germany.
Copyright © 2008, AbTronicX2
- used gel is not
water-based
- the belt is positioned
Incorrectly
- Belt is worn or has
oil deposits.
- Battery is low
- Microprocessor hang
up
- Battery is low
that you use. Make
sure you find "water"
or "aqua" on it.
- Move belt around to
locate your trigger
points.
- Clean conductive
pads or replace. (see
hint below)
- Change Battery
- Perform a RESET,
remove batteries for 1
minute for full RESET
- Change Battery
36