Maintenance; Motion System Components Diagram - Universal Laser Systems VLS2.30 User Manual

Overview
Accumulation of dirt and debris on the motion system components will cause uneven or rough engraving, loss of
engraving position and premature failure. Accumulation of smoke or dirt on optics can result in loss of laser power
and premature failure. It is important to keep your laser system as clean as possible to ensure trouble free
operation and best results from laser processing. Always turn the laser engraving system OFF and unplug it
before performing any cleaning procedures.

Motion System Components Diagram

Note: #2 Mirror Cover and X-Axis rail cover have been removed
for visibility
1. Focus carriage
2. X-Axis bearing (4)
3. #3 mirror (inside cover plate)
4. Focus lens (inside cover plate)
5. X-Axis rail (arm)
6. X-Axis bearing track (2)
7. X-Axis belt
8. X-Axis idler pulley
9. #2 mirror and holder
10. X-Axis motor and drive gear
11. X-home sensor board
12. Y-home sensor board
13. Y-Axis belt (2)
14. Y-Axis bearing (4) (2 on right side
Y-Axis rail, 2 on left side Y-Axis
rail)
15. Y-Axis rail (2)(one right side and
one left side)
16. Y-Axis rail bearing track (2) (one
on right side, one on left side)
17. Y-Axis drive gear (2) (one on right
side, one on left side)
18. Y-Axis shaft (2) (one on right side,
one on left side)
19. Y-Axis shaft flex coupler (one on
right side, one on left side)
20. Y-Axis motor
21. Y-Axis idler pulley (2) (one on right
side, one on left side)
22. Y-Axis home sensor magnet
93