Rotary Fixture - Universal Laser Systems VLS2.30 User Manual

Rotary Fixture

The Rotary Fixture allows the laser system to engrave and mark on cylindrical
objects. The Rotary fixture is equipped with an external cone shaped fixture
mounted to the fixed, motorized end and an internal cone shaped fixture
attached to the adjustable end allowing the fixture to hold a variety of objects
such as wine glasses, mugs, cups, etc. Additional internal and external cone
fixtures can be purchased by contacting the ULS Customer Service Team at
480-609-0297 (USA), +43 1 402 22 50 (Austria), +81 (45) 224-2270 (Japan) or
e-mail us at support@ulsinc.com.
Installation
Remove the engraving table by loosening the two captive thumbscrews (1) and using finger holes (2) lift
1.
the table out of the laser system.
Underneath the engraving table you will find a large recessed slot with a self-aligning rotary connector to
2.
the right side (1) and the two alignment pins (2). If you are using the rotary for the first time or replaced
the laser system's CPU, rotary position calibration may be needed, if so proceed to Rotary Position
Calibration below. If rotary calibration is not needed proceed to step 3
82