Loading Material - Universal Laser Systems VLS2.30 User Manual

Loading Material

Before loading material into the fixture, measure the diameter (1) of the material in the area where the
engraving or marking is to be located, by using a caliper or similar measuring device. A wine glass is used for
illustrative purposes here.
Place the open end of the material (4) on the fixed end of the rotary fixture. Lift the lever (2) on the
8.
adjustable end of the fixture and slide it up against the base of the material so the material rests firmly
centered inside of the inverted cone. Push the adjustable end of the fixture (3) to the right firmly against
the bottom of the material. Lower the lever on the end of the fixture to lock the material in place. The
rubber pads should keep the material from slipping.
Note: If the material does not have an open end you can purchase an additional internal cone fixture to
hold the material. If the material has two open ends you can purchase an additional external cone fixture
to hold the material. To change out fixtures, loosen the setscrew that holds the fixture to the rotary shaft,
remove the un-needed fixture and replace with the new fixture.
Power ON the laser system.
9.
86