Download Print this page

MotoSAT Nomad User Manual page 6

Nomad satellite tv system

Advertisement

1. Dish Network – Can use satellite(s) 119 & 110
2. DirecTV – Can use satellite(s) 101, 110 & 119
3. Bell ExpressVu – Can use satellite(s) 91 & 82
4. Star Choice – Can use satellite(s) 107 & 111
REPEAK – Skewable Mounts ONLY - Pressing the Find button, when
"on satellite" and the signal strength shows weakness, will re-peak the
dish for a higher signal quality when using the twin LNB skewable dish
model(s) MD500 or triple LNB MDHDTV ONLY. (Note: Single LNB
non-skewable dishes "re-peak" during satellite transition.)
STOW: (Stowing the Dish)
Pressing this button returns the dish to its stowed or travel position.
LED'S:
LNB: When lit, this LED indicates the coax cable from the receiver has been
correctly connected to the NOMAD Universal Controller, and the receiver has
power. (Note: The LNB LED is illuminated once the coax cable of the receiver
has been connected, but does NOT indicate the Controller has power).
LOCK: When lit, this LED indicates the "strongest" or "highest" signal strength
of the satellite has been achieved.
PWR: When lit, this LED indicates the NOMAD Universal Controller power has
been turned on.
PEAK: When lit, this LED indicates the dish has found a signal and is adjusting
for the "strongest" or "highest" signal strength of the satellite.
FIND: When the "Find" button has been pressed, the Find LED will blink until a
satellite has been identified and can establish a connection. Once the satellite has
been identified, the Find LED will remain solid. (The Stow LED also blinks
indicating motor movement.) If the Nomad is locked on the satellite, pressing the
"Find" button again will activate a re-peak routine which will verify the dish
alignment to the satellite for optimum signal level for skewable dishes (MD500
and MHDTV). Pressing the Find button on non-skewable dishes (Dome and
Executive) allows you to switch between satellites.
STOW: When the "Stow" button has been pressed, the Stow LED will blink
indicating motor movement as the dish is being stowed. Once the dish has been
stowed, the Stow LED will remain solid.
Dish Services and their Assigned Satellites
5

Advertisement

loading