Advertisement
Using the NOMAD Universal Controller
● Dish Pro 500 (300,500,800) Series Receiver(s) are a
required component when using the Model MD500.
First Time Installation
1-
Plug in all necessary cable connections to the back of the NOMAD (see pg 6).
Note: Plugging the receiver and NOMAD controller into an independent
power strip is recommended.
2-
Connect coax from NOMAD to Mount.
3-
Set the dip switches to match your specific mount model whether it is a Skewable
or Non-Skewable (see pg. 8-9 for specific settings.)
4-
To run the "MANDATORY" Test Dish function, set dip switch #1 to the ON or
UP position, (Note: For non-skewable single LNB dishes, 1 and 3 must be "ON")
then turn the Power Switch to the ON position on the NOMAD controller. There
will be an approximate 15 second delay and the Stow LED will begin to flash,
indicating that the dish is moving. At the completion of the Test, the Stow LED
will go steady. The total Test Time is up to 3 minutes. During the test cycle the
Nomad will run the mount to all extremes and then return it to the stowed
position.
"CAUTION" – TEST DISH ON A NON-
SKEWABLE MOUNT MUST HAVE
SWITCH # 3 IN THE ON POSITION.
:
(Labeled "To Nomad)
3
Advertisement
