Back Panel - Cisco CHS 435HDC Installation Manual

High-defi nition set-top with multi-stream cablecard (m-card) interface
Table of Contents

Advertisement

Back Panel

CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CUIDADO:
RIESGO DE DESCARGA ELÉCTRICA
NO ABRIR
CATV Converter
Made in Mexico
1 FiOS TV In
2 Video Out
3 Audio Out
4 HDTV (YPbPr) Connects to the component input (YPbPr) on the HDTV
5 Audio Out
6 Digital
Audio Out
7 S-Video Out Connects to an S-Video cable that sends an S-Video signal to your TV or
8 IR Remote
Input
9 RF TV Out
10 Optical
Audio Out
11 HDMI 1.3
12 USB 2.0
13 SATA
14 CableCARD
15 IEEE 1394
16 Ethernet
17 AC Outlet
18 AC Power
Input
Note: This illustration may vary from the actual product.
8
Video
STB SN: XXXXXXXXX
L
STB RF MAC: XXXXXXXXXXXX
Audio
This device is intended to be attached to
a receiver that is not used to receive
over-the-air broadcast signals.
Connections of thisdevice in any other
fashion may cause harmful interference
R
to radio communications and is in
violation of the FCC rules, part 15.
SD
FIOS TV In
1
2
3 4 5 67
Connects to a coaxial cable that delivers the signal from your service provider
Connects to the composite input on your TV
Connects to RCA cables that send analog audio signals (left and right)
to the stereo inputs on a TV
Connects to RCA cables that send analog audio signals (left and right)
to the stereo inputs on a TV
Connects to an RCA cable that sends a digital audio signal to a
surround-sound receiver or other digital audio device input
VCR. This signal is standard defi nition, but higher quality than other
SDTV connections
Available to be connected to an approved remote IR receiver
(purchased separately)
Connects to a coaxial cable that sends analog audio and video signals
to a TV or VCR
Connects to an optical cable that sends a digital audio signal to a
surround-sound receiver or other digital audio device input
Connects an HDMI™ cable to the HDMI input of an HDTV. HDMI supports
both digital audio and video. May be used to connect to a DVI interface
using an HDMI-to-DVI adapter for video and separate audio connections.
Any of the following audio connections may be used: Audio Out (3 or 5);
Digital Audio Out (6); or Optical Audio Out (10)
Connects to external USB equipment approved by your service provider
Connects to an external Serial ATA (eSATA) hard disk drive for expanded
drive space. A connected eSATA drive is not an archival device. Ask your
service provider for a list of approved hard drive models for use with the DVR
Slot for CableCARD module, which decrypts subscription digital channels.
This set-top will not operate correctly without a CableCARD module,
which is installed by your service provider
Connects to display devices that are equipped with a 1394 input
Connects to external Ethernet equipment approved by your service provider
Connects to the AC power cord from another device, such as a TV
Connects to the power cord to deliver power to the set-top
Digital
Optical
Audio
Audio
Y
Pb
L
IR Remote
Input
Audio
Pr
R
S-Video
HDTV
RF TV Out
8
9
10
11 12 13 14 15 16
CableCARD
MCARD SN: XXXXXXXXX
MCARD MAC: XXXXXXXXXXXX
1394
USB
SATA Drive
Firewire
Ethernet
17
120 V ~
60Hz 4.2A
500W
120V~
60Hz 40W
LISTED 36MW
VIDEO PRODUCT
18
T14394

Advertisement

Table of Contents
loading

Table of Contents