Connections For A Standard-Defi Nition Tv (Sdtv) - Cisco CHS 435HDC Installation Manual

Connections for a Standard-Defi nition TV (SDTV)
When using the set-top with an SDTV, you must make one of the following connections to
view content. Some SDTVs may not have all these connections. Refer to the user manual
for your TV and the cabling diagrams in this manual for more detailed information.
Although all connections provide you with quality service, we list the connections in our
recommended order.
Notes:
• The labeling on your set-top or SDTV may vary slightly from the illustrations shown below.
• Some cables shown in the connection diagrams may not be included with this set-top.
Use One of These Required
Connections to an SDTV
The YPbPr (red, blue, and green)
connectors can provide standard-defi nition
component video signals to an SDTV. A
separate audio connection is also needed.
See the connection diagram on page 18 for
an example.
Note: To connect YPbPr to an SDTV, you
must select the output video format. See page
30 for more information on picture formats.
The S-Video connection provides an optimal
video connection to SDTVs. A separate
audio connection is also needed.
See the connection diagram on page 19
for an example.
The SD Video connector provides a video
connection to an SDTV. A separate audio
connection is also needed.
See the connection diagram on page 20 for
an example.
The RF TV Out connector provides both a
video and audio connection to an SDTV.
See the connection diagram on page 21 for
an example.
12
Set-Top
Connections
Y
Pb
Pr
L
Audio
R
HDTV
S-Video
L
Audio
R
SD
Video
L
Audio
R
SD
RF TV Out
SDTV
Connections
Y
Pb
Pr
L R
S-VIDEO
IN
L R
VIDEO
IN
L R
CABLE IN/
ANT IN