Connecting To The In-Home Network - Cisco CHS 435HDC Installation Manual

Connecting to the In-Home Network

The following diagrams illustrate examples of the connections you can use to connect
your set-top to your in-home network. Contact your service provider for the recommended
connection method for your home.
Note: The illustrations below may vary from the actual product.
CATV Converter
Made in Mexico
WARNING
: The Ethernet port of this equipment is suitable for connection to
intra-building or unexposed wiring or cabling only. The Ethernet port of this
equipment MUST NOT be metallically connected to interfaces that connect to
the OSP (OutSide Plant) or its wiring. The Ethernet port is designed for use as
an intra-building interface only (Type 2 or Type 4 ports as described in GR-1089-
CORE, Issue 4) and requires isolation from the exposed OSP cabling. The addition
of Primary Protectors is not suffi cient protection in order to connect these
interfaces metallically to OSP wiring.
10
Coaxial
STB SN: XXXXXXXXX
STB RF MAC: XXXXXXXXXXXX
This device is intended to be attached to
a receiver that is not used to receive
over-the-air broadcast signals.
Connections of thisdevice in any other
fashion may cause harmful interference
to radio communications and is in
violation of the FCC rules, part 15.
FIOS TV In
Wall
In-Home
Coaxial
Network
Ethernet
CableCARD
1394
SATA Drive Firewire
OR
In-Home
CAT-5
Network
Ethernet
Wall
T14395