Removing Packaging Materials - HP StorageWorks XP10000 Disk Array Site Prep Manual

Removing packaging materials

The primary rack is labeled DKC AE102A. If you ordered a two-rack system, unpack
the primary rack first because it contains the wooden ramp you will use to unload both
equipment racks.
1.
If shipped in a wooden crate:
a. Using an 11mm (7/16") ratchet or wrench, remove the six lag screws at the
base of the crate.
b. Using the claw end of a claw hammer, remove the crate clamps.
WARNING!
Crate clamps are under tension. Wear safety glasses and hold onto
the clamp with your free hand during removal.
c.
Remove the crate panels.
HP StorageWorks XP10000 Disk Array Site Prep Guide
63