Connecting The European Power-Supply Cables - HP StorageWorks XP10000 Disk Array Site Prep Manual

Connecting the European power-supply cables

Connect each AC power cable to a separate receptacle on a separate circuit breaker,
and connect each pair of power cords (the left pair and the right pair) to separate
distribution panels to ensure power fault tolerance. Single-phase power cable wiring is
shown in the figure below.
CAUTION:
Do not apply power until instructed to do so by HP. An HP representative should be
present whenever the disk array is being connected to a new power source.
CAUTION:
Be sure to connect the power cords to the distribution panel as shown in the figure.
Improper wiring of the neutral conductor may cause damage to the disk array. To
reduce the risk of a wrong connection, use a plug and socket that are approved for
this disk array. It is your electrician's responsibility to select and install the proper
plugs and receptacles.
WARNING!
High leakage current can occur between the power supply and the unit. To avoid
electrical shock, be sure to make the protective earth connection before the supply
connections.
58
Electrical specifications