Kobalt SM1850LW User Manual page 5

SAFETY INFORMATION
POWER TOOL SAFETY
Please read and understand this entire manual before attempting to assemble, operate or install the
product. These safety instructions are not meant to cover every possible condition that could occur.
GENERAL SAFETY INSTRUCTIONS
● LEARN the tool's application, limitations and possible hazards.
● KEEP GUARDS IN PLACE and in working order.
● REMOVE ADJUSTING KEYS AND WRENCHES. Always check to see that keys and adjusting
wrenches are removed from the tool and properly stored before turning it ON.
● KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
● DO NOT USE IN DANGEROUS ENVIRONMENTS. Do not use power tools in damp locations or
expose them to rain or snow. Keep work area well lit.
● KEEP CHILDREN AWAY. All visitors and bystanders should be kept at a safe distance from work
area.
● MAKE WORKSHOP CHILDPROOF with padlocks, master switches or by removing starter keys.
● DO NOT FORCE THE TOOL. It will do the job better and is safer if used at the rate for which it
was designed.
● USE THE RIGHT TOOL. Do not force the tool or an attachment to do a job for which it was not
designed.
● USE PROPER EXTENSION CORDS. Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry the current your product will
draw. An undersized cord will result in a drop in line voltage and in loss of power that will cause the
tool to overheat. The table on page 9 shows the correct size to use depending on cord length and
nameplate ampere rating.
● WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings, bracelets or other
jewelry that may get caught in moving parts. Non-slip footwear is recommended. Contain long hair.
● ALWAYS WEAR EYE PROTECTION. Any power tool can throw foreign objects into the eyes and
could cause permanent eye damage. ALWAYS wear safety goggles (not glasses) that comply with
ANSI Safety standard Z87.1. Everyday eyeglasses have only impact-resistant lenses. They ARE
NOT safety glasses. NOTE: Wearing glasses or goggles not in compliance with ANSI Z87.1 could
lead to serious injury.
● WEAR A FACE MASK OR DUST MASK AND WEAR HEARING PROTECTION. Operating power
tools produces sawdust. Use a dust mask in dusty work conditions. Wear hearing protection during
extended periods of operation.
● SECURE WORK. Use clamps or a vise to hold work when practical. It is safer than using your
hand and it frees both hands to operate the tool.
● DISCONNECT TOOLS FROM POWER SOURCE before servicing and when changing
accessories, such as blades, bits and cutters.
● REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in the OFF position
before plugging in the tool.
● USE RECOMMENDED ACCESSORIES. Consult this Operator's Manual for recommended
accessories. The use of improper accessories may lead to risk of injury to yourself or others.
● NEVER STAND ON THE TOOL. Serious injury could occur if the tool is tipped or if the cutting tool
is unintentionally contacted.
● CHECK FOR DAMAGED PARTS. Check the tool for alignment of moving parts, binding of moving
parts, breakage of parts or mounting and any other conditions that may affect its operation.
Damaged parts should be properly repaired or replaced.
● NEVER LEAVE THE TOOL RUNNING UNATTENDED. TURN THE POWER OFF. Do not walk
away from a running tool until the blade comes to a complete stop. Unplug the unit.
● DO NOT OVERREACH. Keep proper footing and balance at all times.
5