Electrolux Wascator FOM71 CLS Installation Manual page 15

Mechanical installation
• Mark the site of the machine installation.
• The round mark up (A) on the drawing are the
Fig.
site for the feet of the machine.
1
• Two tilt protections shall be mounted for the
two feet at the front of the machine.
• Mark the four holes (B) on the floor.
Fig.
2
• Drill ø8 to a depth of 40 mm. Mount the four
Fig.
expander bolts in the holes.
3
• Lift the machine in the bottom frame and place
it with the feet in the cups. Center the feet in
cups as much as possible.
• Mount the tilt protection and tighten with two
Fig.
screws.
4
• Check that the machine is placed in level.
Adjust with the feet, the lock with the counter
nuts.
It is of utmost importance that the machine
is placed in level, from side to side as well
as front to rear. If the machine is not
properly leveled, it may result in out-of-
balance without a real out of balance in the
drum.
Installation
B
1
A
ø 8
34 650
718
FRONT
2
3
ø 8
A
4
FRONT
4:1
A
A
5744 A
B
5745
4
x 4
B
5746 A
FRONT
5747 + 5748
438 9160-61/01