Electrolux Wascator FOM71 CLS Installation Manual page 9

Pre- programmed wash programs
The Clarus Control in the Wascator FOM71 CLS contains 9 pre-
programmed "wash programs". They are not real wash programs but are
mainly designated for checking purposes. The stored programs are:
Place Name
991 Start-up program
992 Level check
993 Weight check
994 Temperature check
995 Extraction
996 Extraction
997 Extraction
998 Extraction
999 Extraction
Technical data
Content
If the machine has been idle more than
two hours, this program should be run
before any other program is run.
Check with ruler insider
Program fills machine with water to a
reference level at 160 mm, maintains
this level 20 seconds and press PAUS
and it empties the machine. This
process is repeated five times. After
that, the program fills machine with
water to the following levels one after
the other: 100 mm, 130 mm, 160 mm
and 200 mm. Each level is maintained
40 seconds before emptying.
Program fills the machine with water to
18 kg, wait 30 seconds, rotates 60
seconds and fills to 26 kg (+8) and waits
30 seconds. Then drain.
Program fills machine with water to
130 mm level and warms it in five steps:
25°C for 2 minutes, 40°C for 2 minutes,
60°C for 2 minutes, 80°C for 2 minutes
and 90°C for 2 minutes. The machine is
emptied, filled twice with cold water to a
high level 200 mm and finishes with a
two minute spin cycle 1000 rpm. The
buzzer sounds at the end of the
program.
500 RPM 1 min.
500 RPM 5 min.
775 RPM 2 min.
950 RPM 4 min.
1100 RPM 5 min.
1:5
438 9160-01/02