Safety Information - Martin P3-100 User Manual

Safety Information

Read the safety precautions in this section before
installing, powering, operating or servicing this
The following symbols are used to identify important safety information on the product and in this manual:
This product is for professional use only. It is not for household use.
Read this manual before installing, powering or servicing this product, follow the safety precautions listed
below and observe all warnings in this manual and printed on the product.
If you have questions about how to operate this product safely, please contact your Martin supplier or call
the Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Connect the product to AC mains power within the ranges 115 - 250 V, 47 - 63 Hz only.
• Use only a source of AC mains power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• The unit must be correctly grounded to electrical safety earth at all times.
• US, EU (Schuko) and UK power cables with IEC power input connectors are supplied with the product.
Connect the product to AC mains power using the cable that matches your local power outlet sockets. If
you need to replace the power plug to match any other type of power outlet socket, install a
grounding-type (earthed) listed power plug rated 5 A minimum as directed in this manual. In all cases,
check that the power plug connects correctly to ground (earth).
• Isolate the product from AC mains power if the power cable or power plug is in any way damaged,
defective or showing signs of overheating. Do not reapply power until the faulty item is replaced.
• For pluggable equipment, the socket outlet shall be installed near the equipment and shall be easily
accessible.
• Disconnect the product from AC mains power when not in use.
• There are no user-serviceable parts inside the product. Do not attempt to open the product. If service is
required, contact your Martin supplier or a Martin service partner.
• The product is for use in a dry location only. Protect it from moisture. Do not allow it to become wet.
P R O T E C T I O N F R O M F I R E
• Do not modify the product in any way.
• Do not operate the product if the ambient temperature (Ta) exceeds 50° C (122° F).
Warning! Warning!
Safety hazard. Refer to
Risk of severe manual before
injury or death. installing,
powering or
servicing.
WARNING!
product.
Warning!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
Warning!
Fire hazard.