Table of Contents
Advertisement
Operating and servicing your train set
Triggering the Operating Boxcar
A
Remote-Control Track section (available separately, 6-65149 or 6-12746 for O-27 gauge;
6-65530 for O gauge; or 6-12020 for FasTrack layouts) is required to activate the car.
Refer to the instructions included with the track sections.
1. Carefully close the boxcar door to set the mechanism.
2. Position the release plunger over the magnet on the Remote-Control Track section. The
release plunger is labeled in Figure 11.
3. Press UNCOUPLE on the controller to trigger the car. The door will open, and the figure
will appear.
Figure
Release
plunger
Figure 11. Operating Boxcar
Storing the Operating Boxcar
B
e sure to store your Operating Boxcar properly. Do not pack this car in its box with the
mechanism set. Storing the car with the mechanism set will weaken the spring inside,
and the mechanism could be triggered with any handling.
2
Remote-Control
Track section
Advertisement
Table of Contents
