Power Outlet; Uconnect™ Phone - Dodge Ram 2010 Truck User Manual

ELECTRONICS

POWER OUTLET

• There are four 12-volt power outlets located in the vehicle. Lower left and lower right of
the instrument Panel– without floor mounted shifter. Inside the top storage tray – with
floor mounted shifter. Inside the upper lid of the center storage compartment. Rear of the
center console storage compartment – Quad Cab or Crew Cab. The power outlet(s) are
direct feed from the battery and receive power whether the ignition is ON or OFF. All
accessories connected to the outlet(s) should be removed or turned off when the vehicle
is not in use to protect the battery against discharge.
NOTE: Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the 160
Watt (13 Amp) power rating is exceeded the fuse protecting the system will need to be
replaced.
uconnect™ phone
• The uconnect™ phone is a voice-activated, hands-free, in-vehicle communications
system.
• The uconnect™ phone allows you to dial a phone number with your cellular phone using
simple voice commands.
• Please refer to uconnect™ phone in the uconnect™ User's Manual on the DVD for further
details.
• Any voice commanded system should be used only in safe driving conditions
following local laws and phone use. All attention should be kept on the roadway
ahead. Failure to do so may result in an accident causing serious injury or death.
• Your phone must be turned on and paired to the uconnect™ phone to allow use of
this vehicle feature in emergency situations, when the cellular phone has network
coverage and stays paired to the uconnect™ phone.
NOTE: The uconnect™ phone requires a cellular phone equipped with the Bluetooth
Hands-Free Profile, Version 0.96 or higher. For uconnect™ customer support, call
1–877–855–8400.
Phone Pairing
NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth instructions in your cell phone user guide to complete the phone
pairing setup.
• Press the Phone button
• Wait for the "ready" prompt and beep.
• (After the BEEP), say "uconnect setup".
• (After the BEEP), say "phone pairing".
• (After the BEEP) say, "pair a phone".
• Follow the audible prompts.
• You will be asked to create a four-digit PIN which you will later need to enter into your
phone (typically..settings, bluetooth, device, list, new).
WARNING!
to begin.
34
®