Power Inverter - Dodge Ram 2010 Truck User Manual

2010 ram truck
Hide thumbs Also See for Ram 2010 Truck:
Table of Contents

Advertisement

Programming A Rolling Code System
• At the garage door opener motor (in the garage), locate the "learn" or "training" button.
This can usually be found where the hanging antenna wire is attached to the garage door
opener motor (it is NOT the button normally used to open and close the door).
• Firmly press and release the "learn" or "training" button. The name and color of the
button may vary by manufacturer. Within 30 seconds, return to the vehicle and press the
programmed HomeLink
the device is plugged in and activates, programming is complete.
• If the device does not activate, press the button a third time (for two seconds) to
complete the training.
®
Using HomeLink
• To operate, simply press and release the programmed HomeLink
device will operate.
• Refer to your Owner's Manual on the DVD for further details. If you have any problems
programming HomeLink
on the Internet, at www.HomeLink.com.

POWER INVERTER

NOTE: The power inverter is designed with built-in overload protection. If the power
rating of 150 watts is exceeded, the power inverter will automatically shut down. Once
the electrical device has been removed from the outlet the inverter should automatically
reset. If the power rating exceeds approximately 170 watts, the power inverter may have
to be reset manually. To reset the inverter manually, press the power inverter button OFF
and ON. To avoid overloading the circuit, check the power ratings on electrical devices
prior to using the inverter.
To avoid serious injury or death: Do not use a three-prong adapter. Do not insert any
objects into the receptacles. Do not touch with wet hands. Close the lid when not in
use. If this outlet is mishandled it may cause an electric shock and failure.
®
button twice (holding the button for two seconds each time). If
®
, or require assistance, please call toll-free 1–800–355–3515, or
• A 115-Volt 150–watt power inverter outlet is
located on the lower instrument panel next to
the climate control knob. This outlet can
power cellular phones, electronics and other
low power devices requiring power up to
150 watts.
• To turn on the power outlet, press the switch
once.
• Press the switch a second time to turn the
power outlet off. The status indicator of the
AC power inverter indicates whether the
inverter is producing AC power.
WARNING!
33
ELECTRONICS
®
button and the trained

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents