Timer Recording (HDD & DVD Deck)
Timer programming cannot be made.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 77)
●
Timer recording is in progress.
] Timer programming can't be performed while a timer recording
is in progress. Wait until it finishes.
Timer programming recording does not start.
●
Date and time is not correct.
] Set date and time correctly. (A pg. 77)
S
V
Timer Programming cannot be made.
HOW
IEW
●
Date and time set on the unit is not correct.
] Set date and time correctly. (A pg. 77)
●
The channel position does not correspond to that in the
receiving area.
] Set the correct channel position for the receiving broadcast.
(A pg. 74)
The S
V
system does not timer record properly.
HOW
IEW
●
The unit's channel positions have been set incorrectly.
] Refer to AS
V
System SetupB (A pg. 74) and reperform
HOW
IEW
the procedure.
Automatic Satellite Programme Recording does not start.
●
The satellite receiver is not connected properly to this unit.
] Connect the satellite receiver to the [L-2 IN/DECODER]
connector properly. (A pg. 48)
On the front display panel, A– –:– –B appears.
●
Power failure occurred.
] Set date and time correctly. (A pg. 77)
APROGRAMME FULLB appears on the TV screen during timer
programming.
●
16 programmes have already been timer programmed.
] Clear unnecessary programmes on the unit, then try timer
programming again. (A pg. 47)
The disc space does not increase when recorded titles are
cleared.
●
The PC's data recorded on a DVD-RAM drive cannot be cleared
on this unit.
] Format the disc. (When the disc is soiled, wipe the disc with a
soft dry cloth before formatting.) (A pg. 9, 78)
Other Problems
The image of the TV broadcast appears distorted on the TV
screen.
For basic connection
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
Video output indicator (q) lights off on the front display panel.
For component video connection
] Press PROGRESSIVE SCAN for 3 or more seconds so that the
Video output indicator (q) lights up on the front display panel.
Whistling or howling is heard from the TV during camcorder
recording.
●
The camcorder's microphone is too close to the TV.
] Position the camcorder so its microphone is away from the TV.
●
The TV's volume is too high.
] Turn the TV's volume down.
When scanning channels, some of them are skipped over.
●
Those channels have been designated to be skipped.
] If you need the skipped channels, restore them. (A pg. 75)
The channel cannot be changed.
●
Recording or RetroActive Recording* is in progress.
] Press W to pause recording, change the channel, then press I
to resume recording.
* HDD deck only
Channel settings that were made manually seem to have
changed or disappeared.
●
After the manual settings were made, Auto Channel Set was
performed.
] Perform AClock SetB (A pg. 77).
Malfunction occurs and the unit cannot be power off.
] Reset the unit by disconnecting the AC power plug from the AC
outlet and connect again.
TROUBLESHOOTING
83
EN