Napoleon L485 Installation And Operating Instructions Manual page 19

6 x N570-0080 (#14 x 1/2")
5. Transformer/Rear Cart Panel Installation
Install the transformer and the power bar onto the rear panel as illustrated using (6) M4 x 8mm screws and (6) M4 lock nuts.
Route the power cord through the rubber grommet in the rear panel.
Fit the rear cart panel between the two end panels; ensure the large holes in the rear panel are to the bottom of cart as
illustrated. Fasten using (6) #14 x 1/2" screws, three on each side.
L485RSIB MODEL
6 x N570-0078 (M4 X 8mm) 6 x N450-0032 (M4 LOCK NUTS)
3/8"(10mm)
Ensure power
bar is installed
with covers to
the top.
www.napoleongrills.com
19