Other Hardwired Devices; Zone Expanders; Premier Com300/Com2400 - Texecom Premier 48-W Quick Start Manual

7. Other Hardwired Devices

Zone Expanders

The Premier 48-W can use hardwired expanders in addition to the
onboard wireless. When using the Premier 8XP or the PSU200XP
the address of the first additional expander used should be set to 2
or higher.
Expander zones are preset depending on the network address
assigned, it is therefore crucial that consideration is given when
mapping wireless zones, or zones being used on keypads.

The onboard wireless expander occupies address 1.
Details are given for the available zones in the associated product
manuals. Care should be taken to make sure hardwired zones on
expanders are used correctly and any wireless devices or keypad
zones are NOT using the zone numbers associated with the
expander address.
The table below details which zones are fixed for each expander
network address. These cannot be changed and must be used.
Radio devices and Keypad circuits can be mapped to ANY zone.
Address
2
3
4

Premier COM300/COM2400

Carefully lift the control panel PCB and fix the COM unit into the
space provided with the connection lead attached.
The red lead should be positioned on the uppermost pin of the
COM unit.
INS531
Zones
17 - 24
25 - 32
33 - 40
The control panel end of the connector should be attached with the
red lead on the left most pin of the digi modem connector.
Programming requirements for the COM unit can be found in the
Premier 48 installation manual INS176.
Premier 48-W Quick Start Guide
15