Alpine iXA-W407 Quick Reference Manual page 99

Foot Brake Lead I Parking Brake Lead Connection
Chassis
Battery
Parking brake switch
Foot brake switch
Foot brake lamp
Parking brake lamp
Parking brake lead
Foot brake lead
Pinch
Connector
(sold separately)
(Yellow/Blue)
IXA-W407
, . . - - - - - - - , FOOT BRAKE
(YellowlBlack) Pinch
Connector " - - - - - - - - - - - - - - -..... <>
(sold separately)
PARKING BRAKE
/ 2 i - - - - - - . r - ' - - - - - - - - - - - - - . . j
--~~~~
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
FUSE (SA)
(Optional)
IXA-W407
_---if
(Red)
l
(Yellow)
IGNITION
BATTERY
I---------------~
I
SPST SW (Optional)
I
I I
: 0
"Q-----...... --f
- - - - - - - - - - 1
e
Battery
• If
your vehicle has no ACC power supply. add an SPST (Single-Pole. Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when iXA-W407 is used individually.
• /f the switched power (ignition) lead of the iXA- W407 is connected directly to the positive
(+)
post ofthe vehicle's battery. the iXA- W407 draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
67-EN