Reviewing The Log; System Walk Test; Daytime Tamper - Gaurdall Rascal Super User Manual

12. Reviewing the Event Log
With the system in the 'DAY' mode the user can review the event log. The event log is
organised into 'SET' and 'UNSET' events. The log will show the first to alarm and subsequent
alarms as well as isolated circuits. First to alarm is shown by the relevant LED being 'ON'.
Subsequent alarms are shown by the relevant LED flashing and isolated circuits are shown by
the relevant LED pulsing slowly.
The buzzer will sound whilst reviewing the 'SET' logs and the 'DAY' LED will be 'ON' whilst
reviewing the 'UNSET' logs. To view logs proceed as follows.
Enter the four digit PIN code then press the * key followed by the '9' then the '3' key. The log
routine will start with 'DAY 1 SET'. The remaining logs are viewed by pressing the relevant
key '2' for 2nd event '3' for 3rd etc. on to log 9. Pressing the '0' key gives the last to alarm
condition. To exit the logs press the * key.
The # key will alternate between 'SET' and 'UNSET' logs and can be used at anytime.
The log will automatically be exited if no keys are pressed for 30 seconds.
13. Sounder, Buzzer, Strobe & LED Test
Enter the four digit PIN code then press the * key followed by the '9' key. The buzzer will stop,
all the LED's will be 'ON' after 10 seconds the LED's will go 'OFF'. After the LED test the
buzzer will sound for 5 seconds followed by the sounder and then the strobe. After the test
the buzzer will emit an accept tone and revert to 'DAY' mode. The test can be terminated at
any time by pressing the * key.

14. System Walk Test

The user can "Walk Test" the system and test the operation of each detector circuit (with the
exception of personal attack and fire circuits) as follows.
Enter the four digit PIN code then press the * key followed by the '9' then the '4' key. The
buzzer will emit a low level steady tone. As each device is walk tested the internal buzzer will
give a loud pulsing tone to indicate correct operation of the device.
To exit walk test press the * key.
15. Daytime Tamper Alarm
The system automatically monitors the control panel, remote keypads, the external sounder
and all systems wiring and will automatically generate an alarm if an attempt is made to
interfere with any of these. However, if an attempt occurs during the 'DAY' mode then a local
alarm only is generated and the tamper LED will be 'ON'. To reset the system proceed as
follows.
Enter the four digit code. This will silence the buzzer and a two tone alternating sound will
now be emitted signifying a reset is required. Press the # key to reset the system.