Unsetting After An Alarm - Gaurdall Rascal Super User Manual

8. Unsetting the System
On entering the premises the buzzer will emit a continuous tone. Proceed immediately to the
keypad via the designated entry route and unset the system as follows.
Enter the four digit PIN code within the preset entry time. The buzzer will stop and the system
will revert to 'DAY' mode. If the entry time has less than 10 seconds remaining a 'Hurry Up'
tone will be emitted.
Unsetting via the Keyswitch
On entering the premises the buzzer will emit a continuous tone. Proceed to the keyswitch via
the designated entry route and proceed as follows.

9. Unsetting After an Alarm

On entering the premises after an intrusion a full alarm condition will exist. To clear the alarm
proceed immediately to the keypad via the designated entry route and proceed as follows.
Enter the four digit PIN code, the buzzer will emit an alternating two tone sound, the LED for
the circuit which first caused the alarm will be 'ON' and any subsequent alarm will be shown by
a flashing LED. Re-enter the four digit PIN code and press # key to reset the system.
If a reset is not allowed an error tone will be generated. Call your alarm installer for an
engineer reset.
Insert the key and turn the key back to the
marking. The buzzer will stop and the
system will revert to 'DAY' mode.