Table of Contents
Advertisement
Unsetting After an Alarm via Keyswitch
On entering the premises after an intrusion a full alarm condition will exist. To clear the alarm
proceed immediately to the keypad via the designated entry route and proceed as follows.
10. Chime Setting
The chime function is only available if it has been programmed for the circuits at installation.
To switch the chime function 'ON' or 'OFF' proceed as follows.
Enter the four digit PIN code then press the * key followed by the '9' then the '5' key. Any
circuits that have chime 'ON' will have the relevant LED 'ON'. To turn chime 'ON' or 'OFF'
press the key for the circuit you require to change. Press the * key to exit chime. If chime is
not available then an error tone will be generated.
11. Changing the PIN Code
Enter the four digit PIN code then press the * key followed by the '9' then the '1' key. The right
hand four LED's will be 'ON'. Enter your new four digit PIN code. As each number is
accepted an LED will go out. If your new code has been accepted then an accept tone will be
generated. If the new code is not accepted an error tone will be generated and you must pick
a new code. Until the accept tone is generated your old PIN code is still valid.
Insert the key and turn anticlockwise to the
marking. The buzzer will emit an alternating two
tone sound. The LED for the circuit which caused the
first alarm will be 'ON'.
Turn the key clockwise to the
and then back to the
system.
marking
marking to reset the
Hide quick links:
Advertisement
Table of Contents
