Setting With Circuits Open; Keyswitch Setting - Gaurdall Rascal Super User Manual

3. Setting with Circuits Open

Should the user try to set the system with the circuits open, the system will not set. The
buzzer will emit a pulsed tone and the LED will flash for the open circuit. Enter the four digit
PIN code or press the # to abort setting. Investigate the cause of the problem and clear the
alarm. Once cleared start the setting procedure. If you do not abort the setting procedure
before the exit time expires the internal buzzer will sound. Enter the four digit PIN, the
relevant LED will flash, re-enter your PIN code and press the # key to reset.

4. Keyswitch Setting

Your system may be fitted with an optional three-position keyswitch which permits setting and
unsetting of the system.
The following describes setting the system using the keyswitch.
Keyswitch Setting with Circuits Open
Should the user try to set the system with any circuits open, the system will not set. The
buzzer will emit a pulsed tone and the LED will flash for the open circuit.
Turn keyswitch on to
marking. Buzzer emits a pulsed tone.
After clearing the open circuit the control panel can now be set. Turn keyswitch to
and leave the building by the designated route. The system will set when the exit time has
expired.
Insert the key and turn the key clockwise to
the marking. Remove the key
and leave the premises by the designated
exit route. The system will automatically set
on expiry of the exit time.
Turn keyswitch to the
marking and Clear the open
circuit indicated by the flashing LED.