Introduction - Gaurdall Rascal Super User Manual

1. Introduction

The Rascal Super electronic intruder alarm system uses microprocessor technology to give
you a security system that is flexible to use and which is suitable for all domestic
applications.
The system comprises a main control unit which houses the main printed circuit board and
power supply. The main control unit has an on board keypad for everyday use or
programming. Up to 3 additional remote keypads can be fitted to the system. The keypad(s)
provide the operator with the means to set and unset the system and to programme the
various operator functions described.
The control panel and the keypads are provided with 8 Led's for system status and alarm
information.
Operator Controls and Displays
MAINS
LED
DAY
LED
TAMPER
LED
Operator Codes
Setting and unsetting of the system is normally inhibited unless a Personal Identification
Number (PIN) comprising of four digits is entered via the keypad.
The system is designed to recognise one PIN which may be changed at any time by the user.
Up to three optional keyswitches may be fitted to the system. This facility permits the
keyholder to full set, part set or unset the system. It does not allow access to other system
functions.
2. Normal Setting (Full Set)
Ensure all windows and doors are secure, check that all movement detectors are not
obstructed and proceed as follows.
Enter the four digit PIN code. The buzzer emits a steady tone. Leave the building by the
designated exit route. The system will set when the final door is closed and the exit time
expires.
ALARM LEDS (1 - 5)
MAINS 1 2 3 2
1
4 5
DAY 4 5 TAMPER
7
8
0
*
Rascal
Super
3
NUMERIC
KEYPAD
6
9
#
RESET
BUTTON