Advertisement
STEP 2 — CONNECT TALKSWITCH TO YOUR PC OR NETWORK
TalkSwitch can be set up anywhere in the vicinity of your incoming phone lines
and computing equipment.
•
•
If you're installing a TalkSwitch system with multiple units, or you're adding a
TalkSwitch unit to an existing system, refer to the Networking TalkSwitch on a LAN
section on page 13.
LAN
TalkSwitch CA and CVA models
TalkSwitch VS models
4
TalkSwitch 48-CA, 48-CVA and VS models can be connected to your PC using
a Local Area Network (LAN) or USB connection. CA models also offer a Serial
(RS-232) connection.
The TalkSwitch 24-CA can be connected to your PC using a USB or Serial
connection.
USB
Power
USB Power
LAN
Power
Data
Connection Options
Connect using LAN(Ethernet or IP): Connect one end
of the provided RJ-45 Ethernet cable to the LAN port at
the back of the TalkSwitch unit and the other end
directly to your Ethernet switch. Ensure your computer
is connected to the same switch.
Connect using USB: Using a USB A-to-B cable, connect
the B end to the USB port at the back of TalkSwitch,
and the A end to the USB port of your PC.
Power up TalkSwitch
1. Connect the provided AC adapter to the power port
at the back of the TalkSwitch unit and plug the
adapter into an available power outlet.
Warning! Never use a power adapter other than
the one provided with TalkSwitch.
2. Press the Power button on the front of the unit.
The lights on the front panel will flash for a few
moments during boot-up, then stop. The Data light
will remain lit indicating that the TalkSwitch unit
is on.
T A L K S W I T C H S T A R T G U I D E
Advertisement
