Advertisement
STEP 6 — SAVE SETTINGS TO TALKSWITCH
This step will transfer the settings you have configured
from your computer to the TalkSwitch system.
In the TalkSwitch System Configuration window, select
File -> Save to TalkSwitch... A progress bar indicates
that the configuration information is being sent to
the TalkSwitch system.
STEP 7 — CONNECT TELEPHONES AND PERIPHERALS
Connect incoming (external) telephone lines
Important! Lightning and electrical surges can cause damage to TalkSwitch.
We recommend using surge protection equipment on all external telephone and power
lines connected to a TalkSwitch system.
Single-line connection
(1 incoming phone line per wall phone jack)
Use the RJ-11 telephone cables provided to connect
external phone lines to TalkSwitch. These cables have
a two-wire connector for connection to a single-line
wall jack.
1. Connect one end of the provided RJ-11 telephone
cable to the wall phone jack of an incoming phone
line and the other end to the L1 jack at the back
of the TalkSwitch unit.
2. If necessary, connect additional external phone
lines to the L2, L3 and L4 jacks of the TalkSwitch
unit using the same method.
W W W . T A L K S W I T C H . C O M
Two-wire connector
4-line unit
2-line unit
L2
L1
L3
L4
L2
L1
9
Advertisement
