Rear View Camera; Disc, Usb And Card Operation; Load/Unload Disc, Usb Or Card - Planet Audio P9752B User Manual

21
5 .19 Program Playback
It allows you to enter the order in which you want some chapters/tracks in
DVD/VCD/MP3/WMA/CD to play.
1 During playback, press the PROG button to enter a program interface as
follows:
2 Use the direction buttons to move cursor onto the desired place for inputting
the sequence number.
3 Use the number button to input desired sequence number of title/chapter/
track with desired sequence.
4 Use the direction button to move cursor onto Play item, then press the OK
button to play the programmed titles/chapters/tracks in programmed order;
only pressing the PLAY button also can play the programmed titles/chapters
/tracks in programmed order.
* To exit program playback, firstly press the STOP button, then press the PLAY
button to enter sequence playback; or press the PROG button twice again.
* To remove the all programmed sequence numbers, move the cursor onto
Clear item, then press the OK button.
* To change the programmed sequence, move the cursor onto the item you
want to change, input the desired sequence number.
* During VCD playback, if it is in PBC ON mode, at the same time of entering
the state of program playback, it turns off PBC mode.
5.20 Playback IMAGE files
1. The root menu is displayed on the monitor when beginning to switch on IMAGE
mode. .
In the root menu, the left file sort icon is for MP3/WMA file; the middle file sort
icon is for IMAGE file; the right file sort icon is for VIDEO file. If one of these 3
file sort does not exist, you can not move cursor onto the file sort icon.
2. When displaying the root menu, Press the direction buttons
remote control or direction icons
page up/down the FOLDERS, then tap the Folder your desired to open
the Folder.
After open the Folder, in the same way to select the files to playback
or on the
or on the root menu interface to

4.REAR VIEW CAMERA

The car AV system can make you look at the actual status behind your car
when you change the gear level to the back position.
1) Use an video cable to make the car AV system and the rear view camera con-
nected through the REAR CAMERA INPUT jack in the rear cabinet of the car AV
system and VIDEO OUTPUT jack of the rear view camera.
Make the REAR CAMERA SWITCH line in the rear cabinet of the car AV system
connected to(B+) 12V power supply.
2)In any running mode,the video signal will switch to camera mode(if applicable)
when car is in reverse.
After taking the car out of reverse,it will resume to its previous mode.
Analog on-site backup
Warning:
Always check the surrounding environment. Objects might be reversed. The rear view
camera is designed only to assist while reversing. Due to the limitations of the camera
angle and range, it may cause accidents if the driver relies solely on the reverse camera
and display.
5. Disc and USB Operation
5.1 Load/unload disc or USB
To play files in a disc or card, press the EJECT button to slide down the monitor .
Then insert the disc or card into the disc slot or Card slot.
To unload the disc or card, press the STOP button twice to stop playback, then
press the EJECT button to slide down the monitor and eject disc in the disc slot
and then remove the disc; or push the card firstly and then pull it out of the card slot.
P I C
A N G L E
Analog on-site backup
14