Description Of The Rear Cabinet - Planet Audio P9685B User Manual

HUE
It is for adjusting the hue of the video output.
SATURATION
It is for adjusting the saturation of the video output.
SHARPNESS
It is for adjusting the sharpness of the video output.
5.19.5 SPEAKER SETUP
SPEAKER SETUP
DOWNMIX
DOWNMIX
It is for selecting your desired sound effect when there is not central speaker
and sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.
LT/RT: When playing a disc with PRO LOGIC Dolby stereo effect, choose the
item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose the item, when playing a disc recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
5.l9.6 DIGITAL SETUP
DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
OP MODE
It is for selecting audio output mode
LINE OUT: It can linearly compress the audio signal. So the volume level is lower.
RF REMOD: It can make the volume level higher.
DYNAMIC RANGE
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
DUAL MONO
It is for selecting a desired audio output mode for the left and right ways of signal.
There are 4 modes in all as follows: STEREO, MONO L, MONO R, MIX MONO.

1.7 Description of the Rear Cabinet

GREEN
GREY
RED R
RED R
GREY
BLACK
REAR RCA LINE OUT
GREY
BLACK
WHITE L
WHITE L
BT Antenna
Reversal line White
Parking Line GREEN
YELLOW
BLACK
GRAY
USB LINE IN
VIDEO OUT
GRAY
YELLOW
Note:1. Parking wire must be connected, and the parking brake must be engaged in order for the monitor to work
2. Use the clip e nd of the Ground wire provided by manufacturer to connect Mounting Screw, use the other
end of the Ground wire to connect the negative pole of the power source. Otherwise, the video on scre en
may flaches.
Connecting the parking brake line to the parking brake system built in the car
Parking brake
Parking brake switch
(inside the car)
The Description of the Fixed ISO Female Connector
CONNECTOR A
1.
2.
3.
4. Memory +12V(yellow)
5. Auto Antenna(blue)
6.
7. 12V (To Ignition Key)(red)
8. GROUND(black)
SUBWOOFER
FRONT RCA LINE OUT
Fixing Screw Bolt
Fixed ISO Female Connector
Parking brake wires(Green)
To metallic body or chassis of the car
CONNECTOR B
1. Rear Right Speaker (+)
2. Rear Right Speaker (-)
3. Front Right Speaker (+)
4. Front Right Speaker (-)
5. Front Left Speaker (+)
6. Front Left Speaker (-)
7. Rear Left Speaker (+)
8. Rear Left Speaker (-)