Merlin MT600 Installation And Operating Instructions Manual page 11

23
Program your Radio Wall Control
1. Radio Wall Control (optional)
2. Remote Control Wall Mount (optional)
Activate the opener only when door is in full view, free of
obstruction and properly adjusted. No one should enter or
leave garage while door is in motion. Do not allow children to
operate push button(s) or remote(s). Do not allow children to
play near the door. Locate minimum 1.5m above the floor.
Remote control slide-on wall mount bracket:
-Attach to the wall with 2x ø 3.5 max.flat head screws
(not provided )
-Slide remote control onto wall mount bracket
NOTE: Tightening the wall mount screws will reduce clearance
between bracket and wall.
A 3-channel (3-button) remote control may be used for up to three
Merlin garage door operators.
Program the Receiver to Match Additional Remote Control Code
Using the orange "LEARN" Button:
1. Press and release the orange "learn" button on opener. The learn
indicator light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the button on theradio wall
control that you wish to operate your garage door.
3. Release the button when the opener light blinks. It has learned
the code. If the light bulb is not installed, two clicks will be heard.
Program your Keyless Entry
24
(optional accessory)
Activate the opener only when door is in full view, free of
obstruction and properly adjusted. No one should enter
or leave garage while door is in motion. Do not allow
children to operate push button(s) or remote(s). Do not
allow children to play near the door.
NOTE: Your new Keyless Entry must be programmed to
operate your garage door opener.
Program the Receiver to Match Additional Remote
Control Code
Using the orange "LEARN" Button:
1. Press and release the orange "learn" button (1) on opener.
The learn indicator light will glow steadily for 30 seconds.
2. Within 30 seconds, enter a four digit personal identification
number (PIN) of your choice on the keypad (2), then press
and hold the ENTER button.
3. Release the button when the opener light blinks (3). It has
learned the code. If the light bulb is not installed, two clicks
will be heard.
Using the Motion Detecting Control Panel
(optional accessory):
NOTE: This method requires two people if the Keyless Entry
is already mounted outside the garage.
4. Enter a four digit personal identification number (PIN) of
your choice on the keypad, then press and hold ENTER.
5. While holding the ENTER button, press and hold the
LIGHT button on the Multi-Function Door Control.
6. Continue holding the ENTER and LIGHT buttons while you
press the push bar on the Multi-Function Door Control (all
three buttons are held).
7. Release buttons when the opener light blinks. It has
learned the code. If the light bulb is not installed, two clicks
will be heard.
1
2
1 2
4 5
1 2 3
O –
180 s 60 s
120 s
3
6
7