Flow Plan Bottle Mount - INTERNATIONAL CARBONIC TUACA Installation And Service Manual

FLOW PLAN BOTTLE MOUNT

Note: Chill Shot should be positioned
prior to the following being performed:
1. Remove cap from liquor bottle to be
dispensed from Chill Shot.
2. Locate Bottle Cap Assembly and
Sleeve. 750 ml bottle uses small
sleeve, the 1.75 L bottle uses
medium large sleeve.
3. Install Sleeve on to Bottle Cap
Assembly.
4. Install Bottle Cap Assembly with
Sleeve onto the liquor bottle to be
served.
5. Locate Reserve Strainer and place
into the Bottle Reserve Assembly.
6. Carefully turn liquor bottle over and
install into Chill Shot Bottle Reserve
Assembly.
7. Adjust the Support Assembly to
balance the liquor bottle.
8. Repeat steps 1 through 7 for each
bottle to be served.
9. Plug unit into 110-volt outlet to
engage the condensing unit and
lights. Immediately activate PUSH
switch until a small amount of Tuaca
is dispensed.
10. Tuaca will be ready to dispense in
approximately 15 minutes.
BOTTLE CAP ASSEMBLY
750 ml 1.75 Litre
"Cold Shot"
11
RESERVE STRAINER
"Cold Shot"
SUPPORT ASSEMBLY
10/03
Revised
9/5/04