Rev Menu; Changing The Servo Reversing Values; Point Aux1 Menu; Changing The Auxiliary 1 Point Values - AIRTRONICS M12 User Manual

M12 2.4GHZ FH4T RADIO CONTROL SYSTEM USER'S GUIDE
REv MENU { SERvO REvERSING }
The Servo Reversing function allows you to electronically switch the direction of servo travel. For example, if you rotate the Steering
Wheel to the Right, and the Steering servo moves to the Left, you can use the Servo Reversing function to make the Steering servo
move to the Left. The Servo Reversing function is available for all four channels.
When you change the direction of servo travel, the servo horn may no longer be centered. If this occurs, use the Servo
Sub-Trim function to center the servo horn. For more information, see the Changing the Servo Sub-Trim Values section on
the previous page.

Changing the Servo Reversing Values:

1) From within the SETUP menu, scroll UP or DOWN to highlight the REV menu.
2) Press the ENTER key to open the REV menu. The cursor will default to ST > NOR.
3) Scroll UP or DOWN to highlight the desired Servo Reversing value you would
like to change.
4) Press the ENTER key, then scroll UP or DOWN to change the Servo Reversing
value. Choose from either NOR (Normal) or REV (Reverse).
5) Press the ENTER key, then repeat steps 3 and 4 to change any other desired
Servo Reversing values.
ST, TH, AUX1 and AUX2 setting range is NOR and REV. The default setting for all channels is NOR.
pOINT AUx1 MENU { AUxILIARY 1 pOINT vALUES }
The Point Auxiliary function allows you to program the Auxiliary 1 servo to move up to 6 different Points along its travel, then cycle
through those Points using one of the Trim Switches or the Rotary Dial. For example, if your Model requires a separate 3-position
or more switch to operate a feature, the Point Auxiliary function can be customized to control this. This section details how to
change the actual Point values. For example, if you have 4 Points programmed, you can change the Point values to cycle your
servo from 0 to 20 to 40 to 60 degrees and back again.
Use one of the five Trim Switches or the Auxiliary Dial to cycle through the Point Positions while you're driving. The Auxiliary Lever
is not suitable for use in this situation. The Point Auxiliary function can be toggled OFF and ON while you're driving by Assigning
AUX1 to one of the three Push-Button Switches.
Prior to programming the Auxiliary 1 Point values, you must first change the Auxiliary Channel Operating Mode to
POINT, then choose the number of Points you want to program. For more information, see the AUX TYPE Menu section
on pages 41 ~ 42.
The Step value for the Auxiliary Dial or Trim Switch should be set to 1, otherwise the transmitter won't cycle properly through
the programmed Points. For more information, see the Changing the Trim Switch Step Value section on page 35 or the
Changing the Auxiliary Dial Step Value section on pages 36 ~ 37.

Changing the Auxiliary 1 Point Values:

1) From within the SETUP menu, scroll UP or DOWN to highlight the POINT AX1
menu.
64
SETUp
SETUp