Getting Started - Phonak iCom Quick Manual And Features

Features in iCom
Voice dial
Please refer to the phone user manual for instructions.
Press the Main Button for 2 seconds. After you hear
a beep, say the name of the contact you want to call.*
Last number redial
To redial the last number dialled, press the Main
Button twice. The last number dialled is activated
and the call is made.*
* The phone must support these features and the
features must be enabled by your hearing care
professional.
iCom must be switched on but no call and no
music or FM listening is in progress.
Audio lock
You are using the audio cable (jack) or an FM receiver.
But during a speaker pause or very soft music the audio
signal somtimes drops out.
Then press the ON/OFF button shortly to "lock" the
audio signal.

Getting started

Charging the iCom battery
You can continue to use iCom while it is charging.
Turning your iCom
on and off
press for
2 seconds
G
Setting up Bluetooth devices
Before you start using your iCom with Bluetooth
devices you need to pair the devices. Please refer to
the main user guide for instructions. Pairing code
is "0000".
Using iCom with one or two mobile phones
½ You can connect up to two phones at the
same time with iCom
½ Each phone has its own fixed ringtone
½ To accept an incoming phone call, press the
Main Button shortly. You will hear the
caller's voice in your hearing instruments.
Remember
your voice is picked up by iCom.
½ During a call the second phone cannot be
picked up
½ If two phones are connected at the same time,
Voice dial applies to the last paired
G
Using iCom with a cordless (DECT) or older phones
Using cordless phones (DECT) or older phones
with "Headset" profile only
Note: For these phones the Bluetooth indicator
(blue light) might not blink even if the phone was
paired before.
Step 1: On the phone, type the number you want
to dial or select it from the phone book
Step 2: Briefly press the Main Button (or press it
for 2 seconds if you are already in a streaming
iCom program)
Step 3: Wait for 5 seconds
Step 4: The dialing process will start and your
hearing system switches to the phone program
automatically