Important Safety Information; Appliance Certifi Cation; Btu & Effi Ciency Specifi Cations; Glass Specifi Cations - Quadra-Fire MTV-E2-CSB Installation Manual

1

Important Safety Information

A. Appliance Certifi cation
Model Mt. Vernon Pellet Stove E2
Laboratory OMNI Test Laboratories, Inc.
Report No. 061-S-83-2
Type Solid Fuel Room Heater, Pellet and
Shelled Corn Fuel Burning Type
Standard ASTM E1509-12, ULC S627-00 and
(UM) 84-HUD, Mobile Home Approved.
FCC Complies with Part 15 of FCC Rules.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
The Quadra-Fire Mt. Vernon E2 Pellet Stove meets the U.S. Envi-
ronmental Protection Agency's 1990 particulate emission standards.
NOTICE: This installation must conform with local codes. In
the absence of local codes you must comply with the ASTM
E1509-12, ULC S627-00, (UM) 84-HUD and ULC/ORD-
C-1482.
B. BTU & Effi ciency Specifi cations
EPA Certifi ed:
EPA Certifi cation
Number and Date:
Effi ciency:
BTU Input
BTU Output:
Vent Size:
Fuel:
*BTU will vary, depending on the type of fuel you use in your
appliance. Consult your Quadra-Fire dealer for best results.
C. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 2.9 Amps, Run 2.45 Amps
E. Mobile Home Approved
• This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
October 28, 2014
1.7 grams per hour
Number: 926
Issued: 2014
86.5%
EPA: 18,000 to 52,500
EPA: 13,800 to 37,600
3" or 4" Type 'L' or 'PL'
Wood Pellets & Shelled Corn
• The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home and use only Listed pellet vent
Class "L" or "PL" connector pipe.
• Outside Air Kit, part OAK-3 must be installed in a mo-
bile home installation.
F. Non-Combustible Materials
Material which will not ignite and burn, composed of any
combination of the following:
- Steel
- Brick
- Concrete
- Glass
Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace of 750° C.
G. Combustible Materials
Material made of/or surfaced with any of the following ma-
terials:
- Wood
- Plant Fibers
- Plywood/OSB
Any material that can ignite and burn: fl ame proofed or not,
plastered or un-plastered.
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
7080-131D
MT VERNON E2
- Plaster
- Iron
- Tile
- Slate
- Compressed Paper
- Plastic
- Sheet Rock (drywall)
WARNING
3