Heating Specifications; Electrical Specifications; Epa Compliance - Pelpro HSPP2 Owner's Manual

HEATING SPECIFICATIONS

Approx. Heating capacity (sq. feet) *
Approx. Fuel burn rate per hour **
Hopper Capacity - Home 120
Hopper Capacity – Home 300
¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and
the outside temperature. Fuel size, quality, density and moisture level will also have an effect.
¹¹ Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as
much as 20%. Use PFI listed fuel for best results.
DIMENSIONS
24‖
46 1/2‖
3 3/4‖
Air Inlet
PelPro Heater 300

ELECTRICAL SPECIFICATIONS

Electrical Rating
Watts (operational)
Watts (optional igniter)
A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit
board will be voided if surge protection is not installed before operating this unit.
If power outages or disturbances are a concern, you may wish to purchase a gas powered generator,
solar or battery back-up system. Ensure that it is a ―Positive‖ sign wave and a minimum 1000 watts
continual, as well as surge protection.

EPA COMPLIANCE

This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test
methods by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply ex-
ceeding 35:1 (by ratio) are exempt from EPA regulations.
PRODUCT IS SUBJECT TO CHANGE WITHOUT NOTICE.
PelPro Home & Shop Heater
S
S
PECIFICATIONS
PECIFICATIONS
800 – 2,000
1.5 – 5.5 lbs
120 lbs
300 lbs.
26‖
8 1/4‖
Exhaust
+
+
8 3/4‖ 8 3/4‖
14 1/4‖
Common for
all models
= 115 Volts 60 HZ 2.0 Amps
= 175 (approximately)
= 475 (approximately)
www.pelprostoves.com
Approx. Burn time at lowest setting
Approx. Burn time at lowest setting
Weight
272 lbs.
PelPro Heater 300
225 lbs.
PelPro Heater 120
24‖
31 1/2‖
PelPro Heater 120
80 hrs
200 hrs
26‖
8 1/4‖
Exhaust
+
+
8 3/4‖
3 3/4‖
2‖ Air Inlet
14 1/4‖
8 8