Pg200 Reassembly - MerCruiser GM4 Service Manual

REMOVAL
1. Remove armature bearing as previously de-
scribed.
2. Remove brush holder.
INSTALLATION
1. Push each brush up into its guide to allow spring
to hold it in place, as shown.
c
a - Brush
b - Guide
c - Brush Spring
2. Place brush holder on armature and push
brushes down against commutator, as shown.
a - Brush Holder
b - Commutator
c - Brush
3. Install armature bearing as previously described.
Index
4A - 28 - STARTING SYSTEM
a
b
72072
c
a
b
72069

PG200 Reassembly

1. Install end frame on brush holder. Align holes of
end frame with holes of brush holder. Tighten
screws securely.
b
a - Holes of End Frame
b - Holes of Brush Holder
2. Insert armature into field frame. Align brush hold-
er lead with notch in field frame.
NOTE: Permanent magnets in field frame will pull ar-
mature in place.
a - Brush Holder Lead
b - Notch
b
a
72063
b
a
72062
90-816462 2-695