Advertisement
Fit the flap into place along with W25. Remove the flap and
glue W25 in place.
FUSELAGE:
Now is the time to decide whether you will be powering your
plane with glow or electric power. If you will be using the
electric conversion pack, follow the instructions for the elec-
tric version. Note: Some photos in this area may vary for
each version but the position of the formers are the same.
You will also need to decide if you are using one or two ele-
vator servos. If you are using one servo, you can make an el-
evator joiner wire from 3/32" music wire according to the
plans. This will also give you more room for the throttle servo
in the fuselage. If you use 2 elevator servos on a glow pow-
ered plane, you will need to mount a mini throttle servo on
the firewall box because there is not much room in the fuse-
lage.
NOTE: Be very careful and use a square to insure the first 12
formers are square with the building table. If these parts are
not aligned with the plans and square, other parts such as
the cockpit and firewall box will not fit correctly.
Glue F22A and F22B together as shown (make 2)
Pin the F22 assembly in place over the plans and glue F1A
as shown. (Electric version: Glue F1AE in place of F1A)
Glue F2A thru F5A in place (Electric version: Glue F2AE thru
F5AE in place of F2A - F5A)
Align and glue F6A & F7A in place.
Align F8A so the rivet details face forward and glue in place
Advertisement
