Replacement Of The Supply Cord - Whirlpool K20 Instructions For Use And Installation

REPLACEMENT OF THE SUPPLY CORD

If the replacement if the supply cord is required, please buy a similar supply cord by
one of our service centres. How to operate:
1) Disconnect the supply cord from the mains supply.
2) Remove the top. Unscrew the two rear screws and slide the top frontward's to
disengage it from the front seats.
3) Release the supply cord from the clamp ® (Fig.2).
4) Disconnect the electrical connections from the front control panel and
remove the supply cord.
5) Mount the new supply cord and connect it electrically (Note: yellow-green
opposite symbol ╧). Position it between the water pump and the exterior wall,
and fix it by means of clamp ® (Fig 2.) Please make sure that the length of the
supply cord inside the appliance is sufficient,
6) Remount the top and fix it to the rear wall.