Closing The Front Door Of The Dx100 - YASKAWA DX100 Instructions Manual

I/O Expansion European
Standard (PNP)
A dummy connector is inserted into the CN02 of the 24 VDC power supply connector on
the XOI02B board.
Do not remove this connector because it is inserted to prevent incorrect cable
connections. Removing this connector may result in incorrect connection of the 24 VDC
power cable to the CN02. This prevents power from being supplied normally to the
board, and the board may not start up.
24V
24VU
Not used
Not used
24V
24VU
CN02
NOTE
Correct Connecting
Position
4.5
4 Mounting the XOI02B Board

4.5 Closing the Front Door of the DX100

Dummy connector
* Do not remove the dummy connector inserted in this position.
24VDC
power cable
CN02
Incorrect Connecting Position
* Because the dummy connector is removed,
the 24VDC power cable is incorrectly connected,
and power cannot be supplied to the board.
Closing the Front Door of the DX100
1. Close the door slowly.
2. Turn the two door locks counterclockwise for 90° using a coin or a flat
tip screwdriver.
4-4
24VDC
power cable
CN02
Flat tip screwdriver
Door lock
HW1480826
156527-1CD
24VDC
power cable
CN02
18/36