Lux Products P711 Installation And Operation Instructions Manual page 8

WIRING DIAGRAM NOTES:
(Important, please read all notes before connecting wires)
• If the information provided in the following wiring diagrams does not clearly
represent or match your system, please refer to the "TECHNICAL ASSISTANCE"
section of this manual, and contact us before removing any of your existing
thermostat wiring.
• All of the dashed wires shown in the wiring diagrams are either optional, or
their usage depends upon your specific system type or brand. For example:
Diagram #1 shows the fan wire as optional. If your system does not have a
fan, than this terminal will not be used.
• Terminal letters shown in black represent typical wiring applications.
Depending upon the brand of your specific system or thermostat, your terminal
letters may not match exactly. Terminal letters shown in gray represent other
possible wiring designations that you might see on your existing thermostat
terminals.
• The optional "C" terminal is used for powering the thermostat by the 24-volt
system, using the System Common wire. This can be used alone, or in
addition to installing batteries as a backup. NOTE: connecting the System
Common wire to the thermostat is not necessary for heating and cooling to
function properly.
• If your old thermostat has both a "Y" and "C" wire both present, then "C" is
most likely a System Common wire.
• If your old thermostat has both an "O" and a "B" wire present, then "B" is
likely a System Common wire and may be connected to the "C" terminal.
Connecting a System Common wire to this thermostat's "B" terminal may
damage the thermostat, and also your heating and cooling system.
• If replacing an old thermostat that has a mechanical clock, there may be two
wires labeled as "C" for the clock power. Tape off these wires and do not
connect them to the "C" terminal of this thermostat.
8