N600 dual band wifi gigabit modem router (71 pages)
Summary of Contents for NetComm N300 NP804n
Page 1
Netcomm N300 Wireless Router NP804n Setup Guide 1 ‐ Plug the router into a power outlet using the power pack provided. Check that one or more lights on the front of the router are lit. 2 ‐ Ensure PC is connected to one of the LAN ports on the back of the router. 3 ‐ Open an internet browser (Internet Explorer, Firefox, etc.) 4 ‐ Type 192.168.20.1 into the address bar as shown below. 5 ‐ A pop up dialog box will prompts for username & password. Username: admin Password: admin Click ‘OK’ 6 ‐ Click Internet (on the left) then PPPoE (up the top) to arrive at the display shown above. 7 ‐ Enter Login and Password: Login: [yourusername]@fuzeconnect.net.au Password: [your password] Service Name: should be blank, except for Botany customers where it should be “service1”. 8 ‐ Click Apply. 9 – The router may reboot and may take several minutes to complete the connection. ...
Page 2
Wireless Setup 1 – Click on Wireless. 2 – Use any preferred name as SSID1. 3 – The channel that the wireless uses can be changed by selecting Disable for Auto Channel and choosing a new number from the Channel drop down menu. 4 – Click on Apply. 5 – Click on Security. 6 – Choose any preferred Pre‐shared Key (should be combination of letters and numbers). 7 – Click on Apply. ...
Page 3
Resetting router 1 – To reset the router completely, log into 192.168.20.1 2 – Click Tools (left menu). 3 – Click Back‐up (top menu). 4 – Look for “Restore to factory default” 5 – Click Reset. 6 – The router will now reset, this may take several minutes and you may need to enter the username and password to access the router again. ...