Technical Specifications - Linn SNEAKY MUSIC DS Installation And Setup Manual

SNEAKY MUSIC DS
INSTALLATION AND SETUP

10 TECHNICAL SPECIFICATIONS

Date of introduction March 2008
Type Network music player
Supported file types WAV, FLAC, MP3
Audio sample rates 7.35 k, 8 k, 11.025 k, 12 k, 14.7 k, 16 k, 22.05 k,
24 k, 29.4 k, 32 k, 44.1 k, 48 k, 88.2 k, 96 k,
176.4 k, 192 k
Word depths 16 – 24 bits
Ethernet interface 100Base-T RJ45
Control protocol Compatible with UPnP
UPnP
Local control RS232 x 2 RJ11
Connector types
optical digital output TOSLINK
coaxial digital output RCA phono
line outputs RCA phono
speaker outputs Inverted safety 4 mm BFA Sockets
Output impedance
line outputs 300 Ω
speaker outputs 0.06 Ω
Output voltage
line outputs 2.8 V peak, 2 V rms (0 dBFS)
speaker outputs 15 V peak, 10 V rms (0 dBFS, 16.6 dB gain,
vol. 79)
Output offset
line outputs < 2 mV
speaker outputs < 3 mV
™ media servers,
™ AV 1.0 control points
Signal-to-noise ratio
line outputs Better than -120 dB
Channel balance Better than +/- 0.2 dB
Channel separation
line outputs Better than -120 dB
speaker outputs Better than -100 dB
Gain range -80 dB to +20 dB
Gain resolution 1 dB
Unity gain volume 0 dB = volume 80
Dynamic range 120 dB
Damping factor 67
Signal level for clipping 415 mV rms (0 dBFS, +16.6 dB gain, vol. 79)
Harmonic distortion < 0.03% at 1 kHz at 10 W
Load tolerance Unconditionally stable into all loudspeaker loads
Frequency response
– pre 2.5 Hz – 170 kHz (-3 dB)
– power 2.5 Hz – 48 kHz (-3 dB)
Speaker output voltage 15 V peak
Speaker output power 20 W into 4 Ω
Power consumption
standby 10 W
operational 14 W
maximum continuous 120 W
Mains supply voltage 100 – 120 V ac (±10%) 50 – 60 Hz
(auto-ranging) 200 – 240 V ac (±10%) 50 – 60 Hz
21
www.l i n n.c o .uk