Technical Specifications - Linn SNEAKY MUSIC DS Setup & User's Manual

SNEAKY MUSIC DS
INSTALLATION AND SETUP

7 TECHNICAL SPECIFICATIONS

Date of introduction March 2008
Type Network music player
Supported file types WAV, FLAC, MP3, AIFF
Audio sample rates 7.35 k, 8 k, 11.025 k, 12 k, 14.7 k, 16 k, 22.05 k,
24 k, 29.4 k, 32 k, 44.1 k, 48 k, 88.2 k, 96 k,
176.4 k, 192 k
Word depths 16 – 24 bits
Ethernet interface 100Base-T RJ45
Control protocol Compatible with UPnP
UPnP
Local control RS232 x 2 RJ11
Connector types
optical digital output TOSLINK
coaxial digital output RCA phono
line outputs RCA phono
speaker outputs Inverted safety 4 mm BFA Sockets
Output impedance
line outputs 300 Ω
speaker outputs 0.06 Ω
Output voltage
line outputs 2.8 V peak, 2 V rms (0 dBFS)
speaker outputs 15 V peak, 10 V rms (0 dBFS, 16.6 dB gain,
vol. 79)
Output offset
line outputs < 2 mV
speaker outputs < 3 mV
™ media servers,
™ AV 1.0 control points
Signal-to-noise ratio
line outputs Better than -120 dB
Channel balance Better than +/- 0.2 dB
Channel separation
line outputs Better than -120 dB
speaker outputs Better than -100 dB
Gain range -80 dB to +20 dB
Gain resolution 1 dB
Unity gain volume 0 dB = volume 80
Dynamic range 120 dB
Damping factor 67
Signal level for clipping 415 mV rms (0 dBFS, +16.6 dB gain, vol. 79)
Harmonic distortion < 0.03% at 1 kHz at 10 W
Load tolerance Unconditionally stable into all loudspeaker loads
Frequency response
– pre 2.5 Hz – 170 kHz (-3 dB)
– power 2.5 Hz – 48 kHz (-3 dB)
Speaker output voltage 15 V peak
Speaker output power 20 W into 4 Ω
Power consumption
standby 10 W
operational 14 W
maximum continuous 120 W
Mains supply voltage 100 – 120 V ac (±10%) 50 – 60 Hz
(auto-ranging) 200 – 240 V ac (±10%) 50 – 60 Hz
24
www.l i n n.c o .uk