Kobalt SGY-AIR160TZ Operating Instructions Manual page 9

OPERATING INSTRUCTIONS
2. Set pattern size for desired shape. For full
pattern, open spray pattern adjustment knob
(F1/F2) counterclockwise. For a round pattern,
turn spray pattern adjustment kno
clockwise. (See Figure 2)
3. Turn the fluid adjustment knob (G1/G2) fully
clockwise until closed. (See Figure 3)
4. With the spray gun 6 in. to 9 in. awa y from
workpiece, spray a short burst while turning the
fluid knob counterclockwise. Observe the spray
pattern on the workpiece and adjust the fluid
control knob (G1/G2)(see Figure 3) until desired
pattern/atomization is obtained. If the spray is too
fine (caused by too much air), reduce
pressure or open the fluid control knob (G1/G2) to
spray more paint. If the spray
spitting blobs, reduce the amount of paint with the
fluid control knob (G1/G2) or thin the paint more
(See Figure 4).
NOTE The fluid control knob (G1/G2) can be
adjusted either clockwise or counterclockwise to
finely adjust the pattern
spraying on workpiece, practice a few minutes on a
cardboard target to ensure that the pattern size and
consistency are set correctly.
b F ( 1 F /
is too coarse or
consistency. Before
2
) 2
3
4
the air
Pattern Consistency (Atomization)
9
F2
F1
G1
Paint too fine
Correct
Paint too coarse
G2