Kobalt SGY-AIR160TZ Operating Instructions Manual page 6

SA FETY INFORMATION
Use a face mask/respriator and protective clothing when spraying. Always spray in a
well ventilated area to prevent health and fire hazards. Refer to material saftey data
sheets (MSDS) of spray materials for details.
Certain materials that can be used with this device if coming in direct contact with skin
may cause skin irritation.
Read the label or materials safety data sheet for the materials you intend to use to find
out which materials may cause skin irritation.
Always disconnect tool from air supply before performing any maintenance.
Never use a tool which is leaking air, has missing or damaged parts, or requires repair.
Only use parts and accessories recommended by the manufacturer.
SOME DUST CREATED BY PAINT SPRAYING, POWER SANDING, SAWING,
GRINDING, DRILLING, AND OTHER RELATED ACTIVITIES KNOWN TO THE
STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS, AND OTHER
REPRODUCTIVE HARM. A LISTING OF CHEMICALS CAN BE OBTAINED FROM
www.oehha.ca.gov UNDER PROPOSITION 65. SOME EXAMPLES OF THESE
CHEMICALS ARE:
LEAD FROM LEAD BASED PAINTS
CRYSTALLINE SILICA FROM BRICKS, CEMENT AND OTHER MASONRY
PRODUCTS
ARSENIC AND CHROMIUM FROM CHEMICALLY TREATED LUMBER
YOUR RISK FROM THESE EXPOSURES VARIES, DEPENDING ON HOW OFTEN
YOU DO THIS TYPE OF WORK. TO REDUCE YOUR EXPOSURE TO THESE
CHEMICALS WORK IN A WELL VENTILATED AREA, AND WORK WITH APPROVED
SAFTEY EQUIPMENT, SUCH AS A RESPRIATOR OR DUST MASKS WHICH ARE
SPECIALLY DESIGNED TO FILTER MICROSOPIC PARTICLES.
This latex spray gun is designed for home, farm and commercial use. It handles all kinds
of latex paints. It can be easily and quickly converted from non-bleeder to bleeder,
pressure to siphon feed and internal or external mix air caps. It also features pattern size
control. It can also be converted for use with a separate pressure paint tank.
The pressure for atomization is controlled by the regulator on the air source. The
amount of fluid is adjusted by the fluid control knob, the paint viscosity, and the
air pressure.
Failure to install appropriate water/oil removal equipment could result in damage
to product or workpiece.
Never spray closer than 25 feet to the air compressor. If possible, place compressor
n i a e s p a a r e t o r o
W AR N I N G
m .
N O T E
D A N G E R
6